It's time riding my electric's! E-Go would be first as the sidewalks are so full of sand and dirt. I took the motor shield off to take a quick look. One can clearly see the winding inside the motor and the cooling fan. Next, I take the drive belt and wheel off and tighten every single screw and bolt that I could find. After putting everything back on, I put duck tape around most of the enclosure as a safety measure against water. As can be seen, water can still easily get into the Electronic Control Unit around the heat sink. Battery voltage dropped quite a bit over the winter, from 4 LED's to 2 LED's. It cannot hold charge as good as before. This is going to be the 4th season for this E-Go electric longboard!
0 Comments
Leave a Reply. |
DarrylTaking up longboarding... Archives
November 2018
Categories
All
|